1. Home
  2. Knowledge Base
  3. TCM S Machine
  4. Alarm
  5. PS0201 Feedrate Not Found in Rigid Tap
  1. Home
  2. Knowledge Base
  3. TCM S Machine
  4. PS0201 Feedrate Not Found in Rigid Tap

PS0201 Feedrate Not Found in Rigid Tap

The command F code for a cutting feedrate is a zero. If the value of F command is much smaller than that of the S command, when a rigid tap command is specified, this alarm is generated. This is because cutting is not possible by the lead specified by the program. Modify the program.

 

Quick tip:

Modify program.

Was this article helpful?

Related Articles

Need Support?

Can't find the answer you're looking for?
Contact Support