1. Home
  2. Knowledge Base
  3. TCM S Machine
  4. Alarm
  5. PS0351 Because the Axis is Moving, the Sync Control Cannot Be Used (T Series)
  1. Home
  2. Knowledge Base
  3. TCM S Machine
  4. PS0351 Because the Axis is Moving, the Sync Control Cannot Be Used (T Series)

PS0351 Because the Axis is Moving, the Sync Control Cannot Be Used (T Series)

(T Series) While the axis being subject to synchronous control was moving, an attempt was made to start or cancel the synchronous control by a synchronous control axis selection signal. Use correct procedure for synchronous control.

 

Quick tip:

Use correct procedure.

Was this article helpful?

Related Articles

Need Support?

Can't find the answer you're looking for?
Contact Support