PS0361 Because the Axis is Moving, the Superimposed Control Cannot Be Used (T Series)

  1. Home
  2. Knowledge Base
  3. TCM S Machine
  4. Alarm
  5. PS0361 Because the Axis is Moving, the Superimposed Control Cannot Be Used (T Series)
  1. Home
  2. Knowledge Base
  3. TCM S Machine
  4. PS0361 Because the Axis is Moving, the Superimposed Control Cannot Be Used (T Series)

(T Series) While the axis being subject to superimposed control was moving, an attempt was made to start or cancel the superimposed control by a superimposed control axis selection signal. Use correct procedure.

 

Quick tip:

Use correct procedure.

 

Was this article helpful?

Related Articles