PW0007 X-Address (SKIP) Is Not Assigned

  1. Home
  2. Knowledge Base
  3. TCM S Machine
  4. Alarm
  5. PW0007 X-Address (SKIP) Is Not Assigned
  1. Home
  2. Knowledge Base
  3. TCM S Machine
  4. PW0007 X-Address (SKIP) Is Not Assigned

The X address of PMC could not be assigned correctly. Possible causes are: 1) During the set of parameter No. 3012, the skip signal of the X address was not assigned correctly. 2) During the set of parameter No. 3019, the address other than the skip signal of the X address was not assigned correctly.

 

Quick tip:

Verify parameter Nos. 3012 & 3019 are set correctly.

Was this article helpful?

Related Articles