SP9027 SSPA:27 Disconnect Position Coder

  1. Home
  2. Knowledge Base
  3. TCM S Machine
  4. Alarm
  5. SP9027 SSPA:27 Disconnect Position Coder
  1. Home
  2. Knowledge Base
  3. TCM S Machine
  4. SP9027 SSPA:27 Disconnect Position Coder

The spindle position coder (connector JY4) signal is abnormal or the signal amplitude (connector JY2) of the MZ or BZ sensor is abnormal (unconnected cable, adjustment error, etc.). Check signals from sensor. Readjust the BZ sensor. Replace cable or sensor is signals faulty.

 

Quick tip:

Check signals from sensors

Was this article helpful?

Related Articles