SP9050 SSPA:50 Spindle Control Overspeed

  1. Home
  2. Knowledge Base
  3. TCM S Machine
  4. Alarm
  5. SP9050 SSPA:50 Spindle Control Overspeed
  1. Home
  2. Knowledge Base
  3. TCM S Machine
  4. SP9050 SSPA:50 Spindle Control Overspeed

In spindle synchronization, the speed command calculation value exceeded the allowable limit (the motor speed is calculated by multiplying the specified spindle speed by the gear ratio). Check whether the calculated value exceeds the maximum motor speed. Check spindle override switch.

 

Quick tip:

Check calculations

Was this article helpful?

Related Articles