SP9084 Spindle Sensor Disconnected

  1. Home
  2. Knowledge Base
  3. TCM S Machine
  4. Alarm
  5. SP9084 Spindle Sensor Disconnected
  1. Home
  2. Knowledge Base
  3. TCM S Machine
  4. SP9084 Spindle Sensor Disconnected

The spindle sensor feedback signal is not present. Check for shield ground on feedback cable. Check signals from the sensor. Verify no noise on line. Adjust sensor if necessary. Reroute feedback cable away from power cable. Check continuity of cable. Replace sensor.

 

Quick tip:

Check signals from sensor

Was this article helpful?

Related Articles