Alarm

SP9077 Mismatch Result of Axis Number Check

A mismatch was detected between the axis number check results of the spindle amplifier and those of the CNC. Replace...

SP9078 Mismatch Result of Safety Parameter Check

The result of a safety parameter check by the spindle amplifier conflicts with that of a safety parameter check by...

SP9080 Alarm at the Other SP Amplifier

During inter-spindle amplifier communication, an alarm was generated on the remote spindle amplifier. Remove the cause of the alarm of...

SP9081 1-Rotation Motor Sensor Error

The 1-Rotation signal of the motor sensor cannot be correctly detected. Verify parameters are correct. Check signals from the sensor....

SP9082 No 1-Rotation Motor Sensor

The 1-Rotation signal of the motor sensor is not generated. Check signals from the sensor. Adjust if necessary. If no...

Prev Next