- Home
- Knowledge Base
- TCM S Machine
- Alarm
Alarm
SP9139 Serial Spindle Alarm (d9 on SPM)
Pulse error. Replace the sensor. Quick tip: Replace the sensor.
SP9140 Serial Spindle Alarm (E0 on SPM)
Count error. Take action against noise. Replace the sensor. Quick tip: Check for noise and correct. Replace the sensor.
SP9141 Serial Spindle Alarm (E1 on SPM)
Serial sensor one-rotation signal undetected. Check and correct the sensor parameter setting. Replace the sensor. Quick tip: Check sensor...
SV0001 Sync Alignment Error
In feed axis synchronization control, the amount of compensation for synchronization exceeded the parameter (No. 8325) setting value. This alarm...
SV0002 Sync Excess Error Alarm 2
In feed axis synchronization control, the amount of synchronization error exceeded the parameter (No. 8332) setting value. When the synchronization...