Alarm

SV0403 Card/Software Miss Match

The combination of the axis control card and the servo software is incorrect. Probable causes are given below: 1) The...

SV0404 Improper V-Ready ON

Although the ready signal (PRDY) of the position control was OFF, the ready signal (VRDY) of the control was ON....

SV0407 Excess Error

The difference value of the amount of positional deviation for the synchronization axis exceeded the setting value (during synchronous control...

SV0409 Detect Abnormal Torque

An abnormal load was detected on the servo motor, during Cs axis, or spindle positioning (T series) axis. The alarm...

SV0410 Excess Error (Stop)

The amount of positional deviation during stopping exceeded the parameter (No. 1829) setting value. Check parameter 1829. Check for any...

Prev Next