Alarm

PS0007 Illegal Use of Decimal Point

A decimal point (.) was specified at an address where no decimal point may be specified, or two decimal points...

PS0009 Improper NC-Address

An illegal address was specified, or parameter 1020 is not set. Modify the program. Quick tip: Modify program

PS0010 Improper G-Code

An unusable G-code or G-code corresponding to the function not provided is specified. Modify the program or contact FANUC Technical...

PS0011 Feed Zero (Command)

The cutting feedrate instructed by an F code has been set to 0. This alarm is also generated if the...

PS0015 Too Many Simultaneous Axes

A move command was specified for more axes than can be controlled by simultaneous axis control. Either add on the...

Prev Next