Alarm

PS0020 Over Tolerance of Radius

An arc was specified for which the difference in the radius at the start and end points exceeds the value...

PS0021 Illegal Plane Select

(M Series) The plane selection instructions G17 to G19 are in error. Reprogram so that the same 3 basic parallel...

PS0022 R or I, J, K Command Not Found

The command for circular interpolation lacks arc radius R or coordinate I, J, or K of the distance between the...

PS0023 Illegal Radius Command (T Series)

A negative value is specified for the arc radius R command. In the T series, an arc at an angle...

PS0025 Circle Cut in Rapid (F0) (M Series)

F0 (rapid traverse in one-digit F code feed or inverse feed) was specified during circular interpolation (G02, G03). Modify the...

Prev Next