Alarm

PS0053 Too Many Address Commands (T Series)

(T Series) In the chamfering and corner R commands, two or more of I, J, K and R are specified....

PS0054 No Taper Allowed After CHF/CNR (T Series)

(T Series) A block in which chamfering in the specified angle or the corner R was specified includes a taper...

PS0055 Missing Move Value in Chamfer/Corner R

The travel distance specified in the chamfering or corner R block is smaller than the amount of the chamfering or...

PS0056 No End Point & Angle in Chamfer/Corner R (T Series)

(T Series) In direct dimension drawing programming, both an end point and an angle were specified in the block next...

PS0057 No Solution of Block End (T Series)

(T Series) Block end point is not calculated correctly in direct dimension drawing programming. Modify the program. Quick tip...

Prev Next