Alarm

PS0058 End Point Not Found (T Series)

(T Series) Block end point is not found in direct dimension drawing programming. Modify the program. Quick tip; Check...

PS0060 Sequence Number Not Found

[External data input/output] The specified number could not be found for program number and sequence number searches. A request was...

PS0061 P or Q Command is Not In The Multiple Repetitive Cycles Block (T Series)

(T Series) Address P or Q is not specified in G70, G71, G72, or G73 command. Modify the program. ...

PS0062 The Cutting Amount is Illegal in The Rough Cutting Cycle (T Series)

(T Series) A zero or a negative value was specified in a multiple repetitive canned rough-cutting cycle (G71 or G72)...

PS0063 Sequence Number Not Found (T Series)

(T Series) The sequence number specified by address P and Q in G70, G71, G72, or G73 command cannot be...

Prev Next