- Home
- Knowledge Base
- TCM S Machine
- Alarm
Alarm
PS0080 G37 Measuring Position Reached Signal is Not Properly Input
(M Series) When the tool length measurement function (G37) is performed, a measuring position reached signal goes 1 in front...
PS0081 G37 Offset No. Unassigned
(M Series) Tool length automatic measurement (G37) was specified without an H-code (automatic tool length measurement function). Modify the program....
PS0082 G37 Specified with H Code
(M Series) H-code and automatic tool compensation (G37) was specified in the same block (automatic tool compensation function). Modify the...
PS0083 G37 Improper Axis Command
(M Series) An error has been found in axis specification of the tool length measurement function (G37). Alternatively, a move...
PS0085 Overrun Error
The next character was received from the I/O device connected to reader/punch interface 1 before it could read a previously...