Alarm

PS0194 Spindle Command in Synchro-Mode

(T Series) A Cs contour control mode, spindle positioning command, or rigid tapping mode was specified during the spindle synchronous...

PS0197 C-Axis Commanded in Spindle Mode

The program specified a movement along the Cs-axis when the signal CON (Dgn G027#7) was off. Correct the program, or...

PS0199 Macro Word Undefined

Undefined macro word was used. Modify the custom macro. Quick tip: Modify custom macro

PS0200 Illegal S-Code Command

In rigid tap, an S value is out of range or is not specified. The parameter (Nos. 5241 to 5243)...

PS0202 Position LSI Overflow

In rigid tap, spindle distribution value is too large (System Error). Replace main pcb. Quick tip: Replace main pcb

Prev Next