Alarm

PS0315 Illegal Nose Angle Command is in the Thread Cutting Cycle (T Series)

(T Series) An invalid tool tip angle is specified in a multiple repetitive canned threading cycle (G76). Modify the program....

PS0316 Illegal Cutting Amount is in the Thread Cutting Cycle (T Series)

(T Series) A minimum depth of cut higher than the thread height is specified in a multiple repetitive canned threading...

PS0317 Illegal Thread Command is in the Thread Cutting Cycle (T Series)

(T Series) A zero or a negative value is specified in a multiple repetitive canned threading cycle (G76) as the...

PS0318 Illegal Relief Amount is in the Drilling Cycle (T Series)

(T Series) Although an escape directions is set in a multiple repetitive canned cutting-off cycle (G74 or G75), a negative...

PS0319 The End Point Command is Illegal in the Drilling Cycle (T Series)

(T Series) Although the Δi or Δk travel distance is set to 0 in a multiple repetitive canned cutting-off cycle...

Prev Next