Alarm

PS0325 Unavailable Command is in Shape Program (T Series)

(T Series) An unusable command was issued in a shape program for a multiple repetitive canned cycle (G70, G71, G72,...

PS0326 Last Block of Shape Program is a Direct Drawing Dimensions (T Series)

(T Series) In a shape program in the multiple repetitive canned cycle (G70, G71, G72, or G73), a command for...

PS0327 Modal That Multiple Repetitive Cycles Cannot Be Done (T Series)

(T Series) A multiple repetitive canned cycle (G70, G71, G72, or G73) was commanded in a modal state in which...

PS0328 Illegal Work Position is in the Tool Nose Radius Compensation (T Series)

(T Series) The specification for the blank side for a tool nose radius compensation (G41 or G42) is incorrect in...

PS0329 The Finishing Shape is not a Monotonous Change (Second Axes) (T Series)

(T Series) In a shape program for the multiple repetitive canned rough-cutting cycle (G71 or G72), the command of the...

Prev Next