Alarm

PS0330 Illegal Axis Command is in the Turning Canned Cycle (T Series)

(T Series) An axis other than the plane is specified in a canned cycle (G90, G92, or G94). Modify the...

PS0334 Offset is out of Effective Range

An offset data which was out of the effective range was specified (malfunction prevention function). Correct offset. Quick tip:...

PS0336 Tool Compensation Commanded More Two Axes (M Series)

(M Series) For a tool length compensation C, an attempt was made to command the offset to other axes without...

PS0337 Excess Maximum Incremental Value

The command value exceeded the maximum amount of incremental (malfunction prevention function). Modify the program. Quick tip: Modify the...

PS0338 Check Sum Error

An incorrect value was detected in a check sum (malfunction prevention function). Modify the program. Quick tip: Modify the...

Prev Next