Alarm

1) When parameter No. 1815#1 is set to “1”, parameter No. 2002#3 is set to “0”. 2) The absolute-position detection...

An unusable G code was used. Modify program. Alternatively, the option for that G code is not installed. Contact FANUC...

(T Series) The positioning command was issued in the speed control mode. Check the SV speed control mode signal (Fn521)....

(T Series) G96.1, G96.2, G96.3, and G96.4 are specified in the block that includes other commands. Modify the program.  ...

The spindle controlled with the servo motor is not set correctly. Check the parameters for the function of spindle control...