Alarm

PS1541 S-Code Zero

“0” has been instructed as the S code. Modify the program. Quick tip: Modify the program.

PS1543 Illegal Gear Setting (T Series)

(T Series) The gear ratio between the spindle and position coder, or the set position coder number of pulses is...

PS1544 S-Code Over Max

The S command exceeds the maximum spindle rotation number. Check S-Code commanded. Quick tip: Check S-Code commanded.

PS1548 Illegal Axis Mode

The spindle positioning (T Series) axis/Cs contour control axis was specified during switching of the controlled axis mode. Use correct...

PS1561 Illegal Indexing Angle (M Series)

(M Series) The specified angle of rotation is not an integer multiple of the minimum indexing angle. Modify the program....

Prev Next