- Home
- Knowledge Base
- TCM S Machine
- Alarm
Alarm
PS5446 No Avoidance at G41/G42
Because there is not interference avoidance vector, the interference check avoidance function of tool radius/tool nose radius compensation does not...
PS5447 Dangerous Avoidance at G41/G42
The interference check avoidance function of tool radius/tool nose radius compensation operation will lead to danger. Check for interference. Modify...
PS5448 Interference to Avoidance at G41/G42
In the interference check avoidance function of tool radius/tool nose radius compensation, a further interference occurs for an already created...
PW0000 Power Must Be Off
A parameter was set for which the power must be turned OFF then ON again. Quick tip: Cycle power...
PW0001 X-Address (*DEC) Is Not Assigned
The X address of the PMC could not be assigned correctly. This alarm may occur in the following case: 1)...