Alarm

SP9043 SSPA:43 Disconnect Position Coder for Differential Speed Mode

The differential speed position coder signal (connector JY8) in SPM type 3 is abnormal. Replace the cable. Quick tip:...

SP9046 SSPA:46 Screw 1-Rotation Position Coder Alarm

An abnormality equivalent to alarm 41 was detected during thread cutting operation. Check and correct the parameter. Check signals from...

SP9047 SSPA:47 Position Coder Signal Abnormal

The A/B phase signal of the spindle position coder (connector JY4) or the A/B phase signal of the MZ or...

SP9049 SSPA:49 High Converted Differential Speed

In differential speed mode, the speed of the other spindle converted to the speed of the local spindle has exceeded...

SP9050 SSPA:50 Spindle Control Overspeed

In spindle synchronization, the speed command calculation value exceeded the allowable limit (the motor speed is calculated by multiplying the...

Prev Next