Alarm

SV0003 Synchronous/Composite/Superimposed Control Mode Can’t Be Continued

Since as axis in synchronization, composite, or superimposed mode caused a servo alarm, the mode could not be continued. If...

SV0004 Excess Error (G31)

The amount of positional deviation during torque limit skip command operation exceeded the limit value of the parameter No. 6287....

SV0005 Sync Excess Error (MCN)

In feed axis control, for synchronization, the difference value of the machine coordinate between a master and slave axes exceeded...

SV0006 Illegal Tandem Axis

For the slave axis under tandem control, absolute position detection is set (parameter bit 5 (APC) of parameter No. 1815...

SV0007 SV Alarm Another Path (Multi Amp)

When a multiaxis amplifier was used in a multipath system across paths, a servo alarm occurred on an axis belonging...

Prev Next