Alarm

PS0203 Program Miss at Rigid Tapping

In rigid tap, position for a rigid M-Code (M29) or an S command is incorrect. Modify the program. ...

PS0204 Illegal Axis Operation

In rigid tap, an axis movement is specified between the rigid M-code (M29) block and G84 (or G74) block. Modify...

PS0201 Feedrate Not Found in Rigid Tap

The command F code for a cutting feedrate is a zero. If the value of F command is much smaller...

PS0205 Rigid Mode DI Signal Off

Although a rigid M code (M29) is specified in rigid tapping, the rigid mode DI signal (Dgn G061.0) is not...

PS0206 Can Not Change Plane (Rigid Tap)

Plane changeover was instructed in the rigid mode. Modify the program. Quick tip: Modify program.

Prev Next