Alarm

PS0207 Rigid Data Mismatch

The specified distance was too short or too long in rigid tapping. Correct the program. Quick tip: Correct program

PS0210 Can Not Command M198/M199

1) The execution of an M198 or M99 command was attempted during scheduled operation. Alternatively, the execution of an M198...

PS0213 Illegal Command in Synchro-Mode

In feed axis control, the following errors occurred during the synchronous operation: 1) The program issued the move command to...

PS0214 Illegal Command in Synchro-Mode

Coordinate system is set or tool compensation (M Series) of the shift type is executed in the synchronous control. Correct...

PS0217 Duplicate G51.2 (Commands) (T Series)

(T Series) G51.2 is further commanded in the G51.2 mode. Modify the program. Quick tip: Modify program

Prev Next