Alarm

PS0361 Because the Axis is Moving, the Superimposed Control Cannot Be Used (T Series)

(T Series) While the axis being subject to superimposed control was moving, an attempt was made to start or cancel...

PS0362 Superimposed Control Axis Composition Error (T Series)

(T Series) This error occurred when: 1) An attempt was made to perform superimposed control for the axis during a...

PS0363 The G28 Was Instructed To The Superimposed Control Slave Axis (T Series)

(T Series) This error occurred when G28 was specified to the superimposed control slave axis during superimposed control. Use correct...

PS0364 The G53 Was Instructed To The Superimposed Control Slave Axis (T Series)

(T Series) This error occurred when G53 was specified to the slave axis being moved during superimposed control. Use correct...

PS0365 Too Many Maximum SV/SP Axis Number Per Path

The number of controlled axes or spindles to be used in one path is not set correctly. Check parameters No....

Prev Next