Alarm

PS5346 Return to Reference Point

The coordinate establishment of the Cs contour control axis is not made. Perform a manual reference position return. 1) When...

PS5362 Convert Inch/Metric at Reference Position

An inch/metric conversion was performed at a position other than the reference position. Perform an inch/metric conversion after returning to...

PS5391 Can Not Use G92 (M Series)

(M Series) Workpiece coordinate system setting G92 cannot be specified. 1) After tool length compensation was changed by tool length...

PS5395 Cs Axis Number Over

The number of axes to be set for Cs-axis contour control exceeds the maximum number allowed in the system. Check...

PS5445 Can Not Command Motion in G39

Corner circular interpolation (G39) of tool radius/tool nose radius compensation is not specified alone but is specified with a move...

Prev Next