- Home
- Knowledge Base
- TCM S Machine
TCM S Machine
PS5448 Interference to Avoidance at G41/G42
In the interference check avoidance function of tool radius/tool nose radius compensation, a further interference occurs for an already created...
PW0000 Power Must Be Off
A parameter was set for which the power must be turned OFF then ON again. Quick tip: Cycle power...
PW0001 X-Address (*DEC) Is Not Assigned
The X address of the PMC could not be assigned correctly. This alarm may occur in the following case: 1)...
PW0002 PMC Address Is Not Correct (Axis)
The X address of the PMC could not be assigned correctly. This alarm may occur in the following case: 1)...
PW0003 PMC Address Is Not Correct (Spindle)
The address to assign the spindle signal is incorrect. This alarm may occur in the following case: 1) The parameter...