- Home
- Knowledge Base
- TCM S Machine
TCM S Machine
SP9037 SSPA:37 Speed Detect Parameter Error
The setting of the parameter for the number of pulses in the speed detector is incorrect. Correct the value according...
SP9041 SSPA:41 1-Rotation Position Coder Error
The 1-Rotation signal of the spindle position coder (connector JY4) or the 1-Rotation of the MZ or BZ sensor (connector...
SP9042 SSPA:42 No 1-Rotation Position Coder Detect
The differential speed position coder signal (connector JY8) in SPM type 3 is abnormal. Replace the cable. Quick tip:...
SP9043 SSPA:43 Disconnect Position Coder for Differential Speed Mode
The differential speed position coder signal (connector JY8) in SPM type 3 is abnormal. Replace the cable. Quick tip:...
SP9046 SSPA:46 Screw 1-Rotation Position Coder Alarm
An abnormality equivalent to alarm 41 was detected during thread cutting operation. Check and correct the parameter. Check signals from...