- Home
- Knowledge Base
- TCM S Machine
TCM S Machine
SP9141 Serial Spindle Alarm (E1 on SPM)
Serial sensor one-rotation signal undetected. Check and correct the sensor parameter setting. Replace the sensor. Quick tip: Check sensor...
SV0001 Sync Alignment Error
In feed axis synchronization control, the amount of compensation for synchronization exceeded the parameter (No. 8325) setting value. This alarm...
SV0002 Sync Excess Error Alarm 2
In feed axis synchronization control, the amount of synchronization error exceeded the parameter (No. 8332) setting value. When the synchronization...
SV0003 Synchronous/Composite/Superimposed Control Mode Can’t Be Continued
Since as axis in synchronization, composite, or superimposed mode caused a servo alarm, the mode could not be continued. If...
SV0004 Excess Error (G31)
The amount of positional deviation during torque limit skip command operation exceeded the limit value of the parameter No. 6287....