TCM S Machine

Although a rigid M code (M29) is specified in rigid tapping, the rigid mode DI signal (Dgn G061.0) is not...

Plane changeover was instructed in the rigid mode. Modify the program.   Quick tip: Modify program.  

The specified distance was too short or too long in rigid tapping. Correct the program.   Quick tip: Correct program

1) The execution of an M198 or M99 command was attempted during scheduled operation. Alternatively, the execution of an M198...

In feed axis control, the following errors occurred during the synchronous operation: 1) The program issued the move command to...