- Home
- Knowledge Base
- TCM S Machine
TCM S Machine
PS0352 Synchronous Control Axis Composition Error (T Series)
(T Series) This error occurred when: 1) An attempt was made to perform synchronous control for the axis during a...
PS0353 The Instruction Was Done For The Axis Which Was Not Able to Move (T Series)
(T Series) This error occurred when: 1) A move command was executed for an axis for which bit 7 (NUMx)...
PS0354 The G28 Was Instructed In With The Reference Position Not Fixed in Sync Mode. (T Series)
(T Series) This error occurred when G28 was specified to the master axis being parking during synchronous control, but an...
PS0355 Parameter of the Index of the Composite Control Axis Set Error (T Series)
(T Series) An illegal composite control axis number (parameter No. 8183) is specified. Check parameter setting and program. Quick...
PS0356 Because the Axis is Moving, the Comp Control Cannot Be Used (T Series)
(T Series) While the axis being subject to composite control was moving, an attempt was made to start or cancel...