Alarm

PS0350 Parameter of the Index of the Synchronous Control Axis Set Error (T Series)

(T Series) An illegal synchronous control axis number (parameter No. 8180) is set. Correct parameter setting. Quick tip: Correct...

PS0351 Because the Axis is Moving, the Sync Control Cannot Be Used (T Series)

(T Series) While the axis being subject to synchronous control was moving, an attempt was made to start or cancel...

PS0352 Synchronous Control Axis Composition Error (T Series)

(T Series) This error occurred when: 1) An attempt was made to perform synchronous control for the axis during a...

PS0353 The Instruction Was Done For The Axis Which Was Not Able to Move (T Series)

(T Series) This error occurred when: 1) A move command was executed for an axis for which bit 7 (NUMx)...

PS0354 The G28 Was Instructed In With The Reference Position Not Fixed in Sync Mode. (T Series)

(T Series) This error occurred when G28 was specified to the master axis being parking during synchronous control, but an...

Prev Next